Phoenix homeowners get new roof installation, tile replacement, and leak repair from our dedicated crew. Operating under Arizona ROC № 123456 with 247 completed roofs documented since 2018.
Every job begins with our crew climbing the roof rather than guessing from satellite photos. Clay tiles survive fifty Arizona summers, but the organic felt underneath turns brittle after fifteen to twenty years of baking under radiant attic heat. We walk the perimeter, lift ten to fifteen field tiles across sun-exposed southern slopes, sound the plywood decking for dry rot around valley intersections, and photograph all deteriorated pipe jack boots.
Every estimate provides verified dollar figures grounded in trade realities. Targeted roof repairs cost between 300 and 1,500 USD per repair, hourly tile adjustments sit at 125 to 150 USD per hour, and full tile replacements range from 15,000 to 40,000 USD per roof depending on square footage, pitch, and valley count. Your quote reflects measured surface area, access constraints, and selected materials.
Installation proceeds through tear-off, structural plywood repairs, dual-layer waterproofing membrane install, and tile re-setting handled entirely in-house without subcontractors. Every day ends with a magnetic sweep of the driveway and perimeter grounds for dropped nails, and all torn felt, rusted valley metal, broken tiles, and old fasteners are loaded directly into our haul-away trailer.
Job Log: Deck prep & high-temp underlayment install
The homeowner noticed water stains along the master bedroom ceiling drywall following a 45-minute July monsoon downpour. Our on-site inspection revealed that while the clay tiles themselves were intact, the underlying 30-pound asphalt felt had oxidized into brittle flakes along the south-facing gable. Wind-driven rain bypassed the tile lap joints and soaked straight through the rotted felt into the interior roof deck.
Teardown covered 820 square feet of clay barrel tiles, with unbroken units stacked for re-use and all disintegrated organic paper stripped down to the bare OSB decking. We replaced two rotted four-by-eight decking sheets near the fascia, rolled out high-temperature self-adhering waterproofing membrane, fastened new pressure-treated wood battens, and re-hung the tiles with corrosion-resistant screws.
High winds tore off twenty laminated shingle tabs along a roof valley in Sunnyslope, exposing rusted twenty-six-gauge valley metal and unsealed fastener penetrations. Rain had worked behind the valley bend during consecutive summer storms, soaking the rafter tails.
Valley reconstruction involved stripping the affected area three feet back in both directions, scraping away dried mastic, installing new twenty-four-gauge galvanized valley flashing with hemmed water-deflector ribs, layering cold-applied waterproofing membrane beneath the metal, and hand-lapping replacement dimensional asphalt shingles with four nails per strip.
A thirty-year-old ranch home in North Phoenix required a full roof restoration. The original concrete interlocking tiles had slipped along the eaves due to rusted wire ties, and the underlayment had turned to black powder across eighty percent of the roof surface. Rather than applying superficial patch sealants that fail under the next summer heat wave, the homeowner engaged our crew for a complete tile roof replacement.
Workers removed all field, ridge, and rake tiles, palletized the unbroken units, and swept the entire deck clear. We replaced 160 square feet of sagging plywood decking around two HVAC curb platforms, installed heavy-duty eave riser flashing, and mechanically fastened dual layers of polymer-modified underlayment across the entire 2,450 square foot envelope. All tiles were reinstalled with mechanical screws and foam adhesives along high-wind perimeters. The project concluded with a full debris haul-away in our dump trailer and driveway cleanup.
Phoenix roofs fail from beneath. Radiant tile temperatures exceed 160 degrees Fahrenheit during June and July, cooking standard organic felts into dust. Here is how our crew layers decking, membranes, and exterior tiles to survive twenty-plus years in the Sonoran desert.
Solid Wood Substrate
Sounded on site for dry rot and sagging. Structural plywood replacement scoped at 350 to 1,200 USD per sq ft for custom rebuild assemblies.
High-Temp SBS Membrane
Resists thermal degradation up to 240 degrees Fahrenheit. Waterproofing recovery cost basis: 3 to 12 USD per sq ft.
Galvanized Metal Valleys
Corrosion-resistant drip edges and valley ribs keep monsoon runoff away from rafter tails and sidewalls.
Clay & Asphalt Exterior
Reflects direct desert solar radiation. Slipped tile repositioning and mastic repairs billed at 125 to 150 USD per hour.
Select your roofing material, primary issue, affected square footage, and roof access complexity. This tool outputs the matching service and operator-confirmed USD price range.
Targeted leak repair covering flashing seals, damaged pipe boots, and cracked shingles. Timeline set after on-site measurement.
Phoenix homeowners compare roofing companies on price per roof, price per repair, material quality, warranty backing, turnaround timeline, and active Registrar of Contractors licensing. Here are our exact confirmed rates.
| Service | Price / Rate Basis | Typical Materials | Timeline Factor | Licence & Scope |
|---|---|---|---|---|
| New Roof Installation | 8,500–30,000 USD per roof | Asphalt shingles, clay tiles, metal panels | After inspection & measurements | ROC № 123456 • 1 roof |
| Tile Roof Replacement | 15,000–40,000 USD per roof | Clay ceramic tiles, SBS membrane, battens | After inspection & measurements | ROC № 123456 • 1 roof |
| Roof Repair | 300–1,500 USD per repair | Galvanized flashing, sealants, shingles | Same day to 48 hours | ROC № 123456 • Spot repair |
| Roofing System & Membrane Repair | 450–2,800 USD per job 350–1,200 USD / sq ft (deck rebuild) 3–12 USD / sq ft (membrane recovery) |
Waterproofing membranes, fasteners, OSB | After inspection & measurements | ROC № 123456 • Deck & surface |
| Tile Roof Repair | 125–150 USD per hour | Replacement clay tiles, wire ties, mortar | Standard hourly crew call | ROC № 123456 • Field service |
Every roof estimate depends on six physical factors verified during our on-site measurement:
Contractor standards rule out jobs that rely on shortcuts. Our crew will not spray elastomeric coatings over rotted felt, and we refuse to nail new asphalt shingles over wet plywood decking without stripping the roof down to solid wood first. If you only want an unpermitted cosmetic patch to clear a real estate closing without replacing failed underlayment, another contractor will suit that request better.
Projects on high-rise commercial towers requiring crane staging above ten stories are likewise excluded. Scott Roofing Company handles residential homes, tile roof replacements, new roof installations, and light-commercial sloped or flat roofs across Maricopa County. Every job receives dedicated crew days, written material specifications, debris haul-away, and active supervision under Arizona ROC № 123456.
Send your address and roof details. We climb the roof, sound the decking, check the valleys, and provide a clear written USD estimate.
Our trucks dispatch throughout Phoenix, Scottsdale, Peoria, Glendale, Deer Valley, and Paradise Valley.
