Five honest roofing services built for Arizona heat

New Roof Installation

We build complete new roofs for Phoenix homes and light-commercial buildings. Our crew strips aged roofs down to bare wood decking or sheets fresh additions from scratch, then installs asphalt shingles, clay ceramic roof tiles, standing-seam metal panels, or waterproofing membranes over heavy underlayment felt and galvanized drip edges.

Every installation starts with high-temperature polymer membranes rolled over clean sheathing before an exterior fastener goes down. We bend twenty-six-gauge valley metal on site, drive four to six pneumatic nails per shingle course along snapped chalk lines, and flash vent pipes with lead or neoprene collars.

Tile Roof Replacement

Concrete and terracotta clay tiles in Phoenix outlive the organic felt underneath them. After fifteen to twenty years of desert summer sun, that felt turns into brittle carbon flakes, letting monsoon rain soak straight into the attic framing. Tile roof replacement solves the failure at the deck and underlayment layer.

Our crew strips every tile course, stacks unbroken tiles on pallets, pulls rotted wood battens, and sounds the plywood decking for soft spots. We roll out dual layers of self-adhering SBS waterproofing underlayment, swap rusted valley metal, screw down new pressure-treated battens, and reset the tiles with corrosion-resistant fasteners. Broken tiles and torn felt leave in our dump trailer.

Full tile roof replacements cost between 15,000 and 40,000 USD per roof because lifting, sorting, re-felting, and resetting heavy clay takes crew days and dump trailers.

Roof Repair

Targeted roof repairs stop active interior leaks, cracked shingles, rusted valley flashing, and split pipe boots without selling a full roof replacement you do not need. We climb the roof, trace the actual water entry point, and rebuild the failed joint instead of smearing mastic over it.

Repairs include lifting adjacent shingles or tiles to inspect the deck, replacing split rubber collars around sewer vents, refitting step flashing against stucco walls, and securing loose rake edges. Most spot repairs conclude within two to four hours on site.

Roofing System & Membrane Repair

Commercial flat decks, residential patio tie-ins, and low-slope wall transitions fail when ponding water or sun blisters split the membrane. Our crew cuts out saturated cores, dries the substrate, and heat-welds or cold-bonds reinforced waterproofing sheets across the seam.

Where monsoon moisture has softened structural wood decking beneath the membrane, our crew replaces rotten four-by-eight plywood sheets and reconstructs custom curb transitions. Pricing reflects the depth of damage: surface membrane and underlayment recovery runs 3 to 12 USD per square foot, custom structural decking rebuilds run 350 to 1,200 USD per square foot, and localized system repair jobs total between 450 and 2,800 USD.

Tile Roof Repair

Phoenix winds and thermal movement cause roof tiles to chatter, slide downward, and expose the underlying deck to UV degradation. Our hourly tile repair service handles slipped tiles, cracked hip caps, mortar ridge repointing, and localized batten adjustments across Maricopa County.

We bring replacement barrel and flat tiles directly to the job site, reset slipped rows with weather-rated mechanical fasteners, swap out cracked field tiles, re-mud deteriorated ridge mortar caps, and tighten perimeter clips. Tile work billed by the hour sits at 125 to 150 USD depending on pitch and access.